- Posts
- 1
- Joined
- Jan 1970
Hello, I’ve been using the CB6000s for some time, and I believe I’ve discovered my preferred method of wearing them. At least in my opinion. Previously, I wore it with the tiniest spacer, but currently there isn’t one at all between the ring and cage structure. The pin is a longer variant, positioned so that the lock rests directly against my body rather than sitting on top of the cage section. While the smallest spacer can fit onto this pin, placing it outside the cage allows for very little movement. I’m using the second-largest size ring; smaller ones might not be suitable.
The results have been positive so far. The protrusion caused by the lock resting atop the cage has disappeared. There’s no more clattering noise either. Since the unit is positioned closer to my body than its usual spot, the weight of the lock doesn’t drag the cage downward. It feels much tighter and more integrated into me personally.
The gap between the ring and the lower part of the cage assembly has shrunk significantly. This makes pulling out feel risky because it would be quite snug between my balls and penis. I suspect extraction would also require more effort (I haven’t tested this yet, nor do I plan to).
Downsides: It might be slightly trickier to clean around. The lock has sharp edges that press against your skin. There’s less room for larger penises. Is it too tight? Perhaps the pin is a bit weakened regarding stress tolerance? Likely incompatible with rings smaller than the second-largest size, though I haven’t confirmed this.
Anyway, feel free to experiment if you’re interested. Share how it works out for you. I expect to post an update soon. I’m feeling quite hopeful about this setup.