Purchasing a Bespoke Device

I’m in the market for a new device and need it to be custom-built or at least heavily customized. I’d appreciate any suggestions.

To sum up: I have two frenum piercings (two rods positioned beneath my shaft) and want to determine how to “lock” one or both within the tube, similar to how a PA can be secured with a PA fixation.

My initial thought is to reach out to steelwerksextereme since their specialty lies in unique custom designs. That said, while I love their devices, I prefer integrated locks over the “special screws” that Steelworxx Extreme uses (I’m not fully convinced you can’t just find another screwdriver to get it off).

I’ll likely ask Dietmar what he could do with a Steelworxx Stealheart. I wonder if he could craft a fixation where the base connects/locks like the PA fix, but features only a single bar extending into the tube on top. This bar would be around 2 inches long—matching the position of my frenum piercing when flaccid. Attached to the end of this bar would be an open-ended ring, slightly wider than my flaccid size, with a small screw-on ball at one tip. Essentially, it’s like a circular barbell, but only one side has the ball; the other end is simply the 90-degree angle of the bar connecting to the base. The ring would be 10 gauge—matching my piercing thickness—as this ring would actually thread through the piercing, replacing it. The Steelheart itself would match my flaccid size, so there wouldn’t be any pulling on the piercing even when I get hard.

Does that sound logical? Do you think it’s feasible? Any other ideas for locking in with frenum piercings? By the way—I had a PA years back. I upsized too much and ended up getting a meatotomy, so another PA isn’t an option.