Do It Yourself Chastity Device....Solved!

…at least for me! Everyone seems to have different things they wish to get out of chastity, but for me, it’s simply I don’t get to cum until my Goddess/wife makes it happen herself. I can do without the stylish stainless steel jobs, the complicated get ups, and most especially, the pain, discomfort, sores, smell, constant cleanup, unpleasant nightly wakeups, and when it gets right down to it, ease of escape of some devices. One caveat. This requires a PA (Prince Albert piercing). My wife finally relented and accepted that anything short is fatally flawed from an escape standpoint. However, the resulting simplicity and security is well worth the rather small amount of pain I experienced. I also get a real charge seeing it - it feels like a collar, set in place by my wife. Anyway, here’s the deal. I had a few hours yesterday morning to get this done before I had to go to work. My first step was literally, to go to Home Depot. It is a DIY project after all, right?! I had a vague idea of how it was going to work and I perused the entire store looking for just the right material. What I found was a bit of plastic tubing used to extend a sink’s drain pipe. It’s jointless, flared, and comes in two basic sizes. I got the 1-1/2” size, but there was also a 1-1/4” size. The former works perfect for me. The idea is that I only have to cover the area behind the head, for about 1-2 inches. The head is exposed fully on top and sides. The bottom of the device extends underneath the head and a slot is cut into it sized for the PA piercing to drop down into. My current prototype has an open-ended design so that the ball of the piercing can be trapped. On either side of the slot are holes that allow a locking device - either a padlock directly, or a cable. Currently, since it’s in testing mode, I have a serialized tie running through it, and my wife has the serial number. Ultimately I will use a padlock. This design keeps the weight of the padlock on the device, rather than on the piercing, and simply traps the piercing from being able to be removed. The size of the tube, combined with the slight flaring inward at the head and the very light weight of the tube, allows the penis to hold the weight of the device and lock, generally speaking. I’ll post the pics. I think I’m proving that a pic is worth a thousand words, by trying to describe this device, but the result is amazing - It feels like I have nothing on, the relevant nerves on my dick are inaccessible, and I sleep with no wake-ups from nocturnal erections. Wow! I used a utility knife and tin snips to make the cuts after first drawing the basic design with a permanent marker. I drilled the holes, and then sanded everything down with fine (320 grit) sandpaper. The sandpaper removed all the markings from the plastic and did a fantastic job of taking off all burrs and smoothing the plastic. It looked way more professional afterwards, too. My wife is very pleased with my work. Future designs will eliminate the open slot in the front by extending the length of the bottom lip a centimeter or so. This will let me rotate the ball inside and against the bottom of the penis and make it inaccessible for naughty cucks. Right now, my piercing is only days old, so there’s no way I’m messing with trying to remove the jewelry, but that will change. I’m sure there’s variations that can be done using locking piercing jewelry. That’s the fun of DIY - making it work perfectly for your situation!