Chastity device discussions and reviews discussion

You might not know this yet. It was definitely a surprise for me—a fresh device by pedro99, printed in 3D. I spotted it on a random Tumblr post and gave it a go. The total cost landed around $170 after exchanges (I purchased two cage parts and two ring parts, so splitting the difference puts us at about that price. lol.) Here is what I picked up: 2 x 45mm rings—one without a tab, one with—and 2 cages. One was standard short, the other a shorter summer edition. Initial thoughts: Construction: The quality stood out as quite solid. There were some minor discolorations on both the cage and ring sections of one unit, but otherwise, no complaints. I’m curious about their durability now that they are in use. You can see tiny ridges left over from the printing process. Comfort/Fit: The tabbed version grips nicely and keeps everything secure. Honestly, it is probably the most comfortable piece of equipment I own compared to my other devices (CB3000, curve, Birdlocked original & small, CB6K/S, PA5000, Steelheart, Chinese SS variants, CS100 clone, T3 belt). It just works for me—though everyone’s anatomy differs despite the similarities. I can even wear the non-tabbed ring during workouts (light cardio plus squats or deadlifts/lunges). The tube rests close against my body and presses in slightly. I have only had it on for about 12 hours so far. [[Image: 20140926_133638 (Large).jpg]](the referenced community page) [[Image: 20140926_134110 (Large).jpg]](the referenced community page) [[Image: 20140926_134236 (Large).jpg]](the referenced community page) [[Image: 20140926_134257 (Large).jpg]](the referenced community page) [[Image: 20140926_134511 (Large).jpg]](the referenced community page)